Fleece's new line of PowerFlo in-tank lift pump assemblies are an awesome alternative to the widely used frame mounted lift pumps from FASS and AirDog. These pumps utilize factory plumbing and wiring which makes installation into your Cummins clean and simple.
The PowerFlo Lift Pump is the latest OEM replacement performance lift pump from the diesel experts at Fleece Performance. The PowerFlo is the only in-tank lift pump capable of supporting up to 800 hp!
Direct OEM In-Tank Replacement:
The PowerFlo Lift Pump retains the factory water-in-fuel sensor, factory fuel heater, factory fuel lines, and installs in less than half the time of other high flow lift pumps.
Two is always better than one, and the PowerFlo delivers with two OEM quality gerotor pumps, increasing flow capacity and reliability over the factory pump. Capable of supporting up to 800 hp, including dual CP3 pump configurations.
The active fill bucket eliminates the need for tank sumps, draw straws, additional air filtration, and the ¼ tank issues typically encountered when seeking a higher flow lift pump to meet your engine’s need.
Want the benefits of the in-tank pump but need to run your own fuel lines or aftermarket filters? The pump outlet and return is threaded to accept a -8 O-ring fitting (3/4"-16 thread).
The PowerFLo Lift Pump is also backed by a LIFETIME WARRANTY!
Part Number Reference Table:
FPE Part Number
Replaces Dodge/Ram OE Part Number
Drop-In Lift Pump
170 GPH @ 15 PSI
Supports 800 RWHP
Uses Factory Connections
No Sump Or Draw Straw Needed
In-Tank Installation For Silent Operation
Regulated Return Flow Eliminates Over Pressure Situations