Yukon Pinion Bearing and Seal Kit for 2001-2010 GM 9.25" IFS Front Axle

Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses Timken bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, pinion nut, thread locker, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.

Included are pinion bearings and races, pinion seal, crush sleeve, complete pinion shim kit, and marking compound with brush.

2001-2010 Duramax IFS 9.25" 2500HD/3500HD

COMPATIBLE DIFFERENTIALS
GM 9.25" IFS Front, '10 & down
COMPATIBLE MAKE / MODEL
Chevrolet / Chevy Avalanche 2500 (2002 - 2006)
Chevrolet / Chevy K20/K2500 3/4 Ton (4WD) (1988 - 2000)
Chevrolet / Chevy K30/ K3500 1 Ton (4WD) (1989 - 2000)
Chevrolet / Chevy Silverado 2500 3/4 Ton (1999 - 2010)
Chevrolet / Chevy Silverado 3500 1 Ton (2001 - 2010)
Chevrolet / Chevy Silverado HD 1500 1/2 Ton (2001 - 2007)
Chevrolet / Chevy Silverado HD 2500 3/4 Ton (2001 - 2010)
Chevrolet / Chevy Silverado HD 3500 1 Ton (2001 - 2010)
Chevrolet / Chevy Suburban 3/4 Ton (1988 - 2010)
GMC K25/ K2500 3/4 Ton (4WD) (1988 - 2000)
GMC K35/K3500 1 Ton (4WD) (1988 - 2000)
GMC Sierra 1500 HD 1/2 Ton (2001 - 2007)
GMC Sierra 2500 3/4 Ton (1999 - 2010)
GMC Sierra 2500 HD 3/4 Ton (2001 - 2010)
GMC Sierra 3500 1 Ton (2001 - 2010)
GMC Sierra 3500 HD 1 Ton (2001 - 2010)
GMC Sierra Denali (2000 - 2010)
GMC Yukon 2500 3/4 Ton (1992 - 2010)
GMC Yukon XL 2500 3/4 Ton (2000 - 2010)
Hummer H2 (2002 - 2009)