Yukon Pinion install kit for 2011 & up GM LML & Chrysler 11.5" differential

Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings & races can be reused. This kit uses Timken bearings and races along with a high quality pinion seal and small parts. Included in this kit are the pinion bearings and races, pilot bearing (if applicable), crush sleeve (if applicable), complete pinion shim kit, pinion nut, thread locker, and marking compound with brush. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your pinion gear.

NOTE:
In mid 2011 the design for the pinion bearing changed. The early design had a rear pinion race O.D. of 4.125". The later design has an O.D. of 4.375". This kit is the 4.125" design.

COMPATIBLE DIFFERENTIALS
GM 11.5", 2011 & up
Chrysler 11.5", 2011 & up w/ Leaf Spring, 12 Bolt R/G
Chrysler 11.8" / 300mm, 2013.5+ w/ 6.7L & Aisin A/T, 12 Bolt R/G
COMPATIBLE MAKE / MODEL
Chevrolet / Chevy Silverado 2500 3/4 Ton (2011 - 2018)
Chevrolet / Chevy Silverado 3500 1 Ton (2011 - 2018)
Chevrolet / Chevy Silverado HD 2500 3/4 Ton (2011 - 2018)
Chevrolet / Chevy Silverado HD 3500 1 Ton (2011 - 2018)
Dodge Power Wagon (2014 - 2018)
Dodge Ram 2500 3/4 Ton (2011 - 2013)
Dodge Ram 3500 1 Ton (2011 - 2018)
GMC Sierra 2500 3/4 Ton (2011 - 2018)
GMC Sierra 2500 HD 3/4 Ton (2011 - 2018)
GMC Sierra 3500 1 Ton (2011 - 2018)
GMC Sierra 3500 HD 1 Ton (2011 - 2018)